Specifications

3-84
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.51 OPR-PROTNSW-<STS_PATH>: Operate Protection Switch (STS1, STS3C,
STS6C, STS9C, STS12C, STS24C, STS48C, STS192C)
(STS192C supported for ONS 15454 only)
This command instructs a SONET NE to initiate a SONET path protection (UPSR) switch request. User
switch requests initiated with this command (forced switch, lockout, and manual switch) remain active
until they are released through the RLS-PROTNSW-<STS_PATH> command or overridden by a higher
priority protection switch request.
Notes:
1. This command applies to UPSR configuration only.
2. The VTAID should be working or protect AID only.
3. If you send this command on the Drop AID, a DENY (Invalid AID, should use working/protect AID)
message will be returned.
4. To get the protection switching state (manual, lockout, forced), use the RTRV-COND-ALL or
RTRV-ALM-ALL commands.
Related
Messages
DLT-FFP-<OCN_TYPE>
ED-FFP-<OCN_TYPE>
ENT-FFP-<OCN_TYPE>
EX-SW-<OCN_BLSR>
RLS-PROTNSW-<OCN_TYPE>
RTRV-FFP-<OCN_TYPE>
Input Format OPR-PROTNSW-<OCN_TYPE>:[<TID>]:<AID>:<CTAG>::<SC>,[<ST>];
where:
• <AID> identifies the facility in the NE to which the switch request is directed
and is from the “FACILITY” section on page 4-11
• <SC> is the switch command on the facility; valid values for <SC> are shown
in the “SWITCH” section on page 4-59
• <ST> is the BLSR switch type. The switch type is optional, and for BLSR
protection switch only. <ST> defaults to RING switch type and valid values are
shown in the “SWITCH_TYPE” section on page 4-59
Input Example OPR-PROTNSW-OC48:CHICKALUMA:FAC-6-1:204::LOCKOUT,SPAN;
Errors This message generates all the default errors
Section OPR-PROTNSW-<OCN_TYPE> Description (continued)
Section OPR-PROTNSW-<STS_PATH> Description
Category UPSR Switching
Security Maintenance
Related
Messages
OPR-PROTNSW-VT1
REPT SW
RLS-PROTNSW-<STS_PATH>
RLS-PROTNSW-VT1