Specifications

3-81
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.48 OPR-EXT-CONT: Operate External Control
This command operates an external control and closes the external control contact.
Notes:
1. The duration has one value in this release: CONTS, Continuous duration
2. In an automatic state, the contact could be opened or closed depending on the provisioned trigger.
3. RLS-EXT-CONT changes the state to automatic. Therefore, issuing an OPR-EXT-CONT command
when the control is manually open and then issuing a RLS-EXT-CONT will not revert the state back
to Manual Open.
4. A NULL value for the duration parameter defaults to CONTS.
Input Example INIT-SYS:HOTWATER:SLOT-8:201;
Errors This message generates all the default errors
Section INIT-SYS Description (continued)
Section OPR-EXT-CONT Description
Category Environmental Alarms and Controls
Security Maintenance
Related
Messages
REPT ALM ENV RTRV-ATTR-ENV
REPT EVT ENV RTRV-COND-ENV
RLS-EXT-CONT RTRV-EXT-CONT
RTRV-ALM-ENV SET-ATTR-CONT
RTRV-ATTR-CONT SET-ATTR-ENV
Input Format OPR-EXT-CONT:[<TID>]:<AID>:<CTAG>::[<CONTTYPE>],[<DURATION>];
where:
• <AID> is the access identifier from the “ENV” section on page 4-10 and must
not be null
• <CONTTYPE> is the type of control; valid values for <CONTTYPE> are shown
in the “CONTTYPE” section on page 4-34
• Valid values for <DUR> are shown in the “DURATION” section on page 4-36.
A null value is equivalent to ALL.
Input Example OPR-EXT-CONT:CISCO:ENV-OUT-2:123::AIRCOND,CONTS;
Errors This message generates all the default errors