Specifications
3-75
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.42 INH-MSG-DBCHG: Inhibit Database Change Message
This command disables REPT DBCHG.
3.5.43 INH-SWDX-EQPT: Inhibit Switch Duplex Equipment
(Cisco ONS 15454 only)
This command instructs the NE to inhibit automatic or manual switching on a system containing duplex
equipment. Use the ALW-SWDX command to release the inhibit. This command is not used for SONET
line protection switching. For SONET line/path protection switching commands, use the
OPR-PROTNSW and RLS-PROTNSW commands. This command is not used for 1:1 and 1:N equipment
protection switching, use ALW-SWTOPROTN, ALW-SWTOWKG, INH-SWTOPROTN,
INH-SWTOWKG commands.
Notes:
1. This command is applied for XC or XCVT equipment units only in this release.
2. When sending this command to a TCC+ card, an error message will occur because the NE treats the
TCC+ as a non-revertive protection group without user control.
Section INH-MSG-DBCHG Description
Category Log
Security Retrieve
Related
Messages
ALW-MSG-DBCHG
REPT DBCHG
RTRV-LOG
Input Format INH-MSG-DBCHG:[<TID>]::<CTAG>[::,,];
Input Example INH-MSG-DBCHG:CISCO::123;
Errors This message generates all the default errors
Section INH-SWDX-EQPT Description
Category Equipment
Security Maintenance
Related
Messages
ALW-SWDX-EQPT REPT ALM EQPT
ALW-SWTOPROTN-EQPT REPT EVT EQPT
ALW-SWTOWKG-EQPT RTRV-ALM-EQPT
DLT-EQPT RTRV-COND-EQPT
ED-EQPT RTRV-EQPT
ENT-EQPT SW-DX-EQPT
INH-SWTOPROTN-EQPT SW-TOPROTN-EQPT
INH-SWTOWKG-EQPT SW-TOWKG-EQPT
Input Format INH-SWDX-EQPT:[<TID>]:<aid>:<CTAG>[::];
where:
• <AID> is the XC/XCVT equipment AID (Slot 8 or Slot 10) from the “EQPT”
section on page 4-11