Specifications

3-74
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.41 INH-MSG-ALL: Inhibit Message All
This command instructs the NE to enter a mode in which all REPT ALM and REPT EVT autonomous
messages are prevented from being transmitted. See the ALW-MSG-ALL to resume these autonomous
messages. When a TL1 session starts, the REPT ALM and REPT EVT messages are allowed by default.
Note If this command is used twice in the same session, the SAIN (Already Inhibited) error message will be
reported.
Related
Messages
DLT-FFP-<OCN_TYPE>
ED-FFP-<OCN_TYPE>
ENT-FFP-<OCN_TYPE>
OPR-PROTNSW-<OCN_TYPE>
RLS-PROTNSW-<OCN_TYPE>
RTRV-FFP-<OCN_TYPE>
Input Format EX-SW-<OCN_BLSR>:[<TID>]:<AID>:<CTAG>[::<ST>];
where:
• <AID> identifies the facility in the NE to which the switch request is directed.
<AID> is from the “FACILITY” section on page 4-11. <AID> must not be null.
• <ST> is the BLSR switch type. the switch type is optional and for BLSR
protection switch only. <ST> defaults to RING switch type and valid values are
shown in the “SWITCH_TYPE” section on page 4-59. A null value is equivalent
to ALL.
Input Example EX-SW-OC48:CISCO:FAC-12-1:123::SPAN;
Errors This message generates all the default errors
Section EX-SW-<OCN_TYPE> Description (continued)
Section INH-MSG-ALL Description
Category System
Security Retrieve
Related
Messages
ALW-MSG-ALL RTRV-INV
ED-DAT RTRV-NE-GEN
ED-NE-GEN RTRV-NE-IPMAP
ED-NE-SYNCN RTRV-NE-SYNCN
INIT-SYS RTRV-TOD
RTRV-HDR SET-TOD
Input Format INH-MSG-ALL:[<TID>]::<CTAG>[::,,];
Input Example INH-MSG-ALL:PETALUMA::550;
Errors This message generates all the default errors