Specifications

3-62
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.32 ED-T3: Edit T3 Facility
This command edits the attributes related to a DS3/T3 port.
Notes:
1. This command is not allowed if the card is a protecting card.
2. Both FMT and Line code are not supported for T3/DS3 facility. They are supported on both the
DS3XM and DS3E card. The unframed value of the framing format is only supported on the DS3E
facility.
3. If sending this command to edit TACC and any other attribute(s), and the port having the cross
connection, the (Parameters Not compatible) error message will be returned.
4. Editing TACC via an ED-xxx command is only allowed when there is no circuit/cross connection
on the port and the port/VT does not have a TAP. Otherwise, an error message (VT in Use) will be
returned.
5. TACC creation will also be denied on the protect ports/cards.
Section ED-T3 Description
Category Ports
Security Provisioning
Related
Messages
ED-<OCN_TYPE> RTRV-<OCN_TYPE>
ED-DS1 RTRV-DS1
ED-EC1 RTRV-EC1
ED-G1000 RTRV-G1000
ED-T1 RTRV-T1
RMV-<MOD_PORT> RTRV-T3
RST-<MOD_PORT>
Input Format ED-T3:[<TID>]:<AID>:<CTAG>:::[FMT=<FMT>,][LINECDE=<LINECDE>,]
[LBO=<LBO>,][TACC=<TACC>][:<PST>];
where:
• <AID> is the facility AID from the “FACILITY” section on page 4-11
• <FMT> is the frame format and the unframed value of the framing format is only
supported for the DS3E; valid values for <FMT> are shown in the
“DS_LINE_TYPE” section on page 4-36
• <LBO> is the line buildout; valid values for <LBO> are shown in the “E_LBO”
section on page 4-36
• <LINECDE> is the line code; valid values for <LINECDE> are shown in the
“DS_LINE_CODE” section on page 4-35
• <TACC> defines the STS as a test access port with a selected unique TAP
number. The TAP number ranges from 0–999. When TACC is 0, the TAP is
deleted; <TACC> is an integer
• <PST> is the state; valid values for <PST> are shown in the “PST” section on
page 4-53