Specifications

3-51
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
Input Format ED-BLSR:[<TID>]:<AID>:<CTAG>:::[RINGID=<RINGID>,]
[NODEID=<NODEID>,][RVRTV=<RVRTV>,][RVTM=<RVTM>,]
[SRVRTV=<SRVRTV>,][SRVTM=<SRVTM>][:];
where:
• <AID> identifies the BLSR of the NE and is from the “BLSR” section on
page 4-9 (the AID “ALL” or “BLSR ALL” is not allowed for editing BLSR).
This command only supports a single BLSR AID.
• <NODEID> identifies the BLSR node ID of the NE. It ranges from 0–31.
<NODEID> is an integer.
Note <NODEID> cannot be edited in this release.
• <RINGID> identifies the BLSR ring ID of the NE. It ranges from 0–9999.
<RINGID> is an integer.
Note <RINGID> cannot be edited in this release.
• <RVRTV> identifies the revertive mode and valid values are shown in the
“ON_OFF” section on page 4-51
• <RVTM> identifies the revertive time and is not allowed to be set while
<RVRTV> is N (non-revertive mode); valid values for <RVTM> are shown in
the “REVERTIVE_TIME” section on page 4-55
• <SRVRTV> identifies the span revertive mode for 4F BLSR only and valid
values are shown in the “ON_OFF” section on page 4-51
• <SRVTM> identifies the span revertive time for 4F BLSR only and is not
allowed to be set while <SRVRTV> is N (non-revertive mode); valid values for
<SRVTM> are shown in the “REVERTIVE_TIME” section on page 4-55
Input Example ED-BLSR:PETALUMA:BLSR-43:123:::RVRTV=Y,RVTM=2.0,SRVRTV=Y,
SRVTM=5.0;
Errors This message generates all the default errors
Section ED-BLSR Description (continued)