Specifications

2-25
Cisco AS5x00 Case Study for Basic IP Modem Services
11/24/1999
Section 2 Commissioning the Cisco AS5300 Hardware
Configuring Modems and Lines
Step 2
Verify that the asynchronous TTY lines support incoming and outgoing calls. These lines are simulated
R2-232 ports.
5300-NAS#show line
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 0 CTY - - - - - 0 0 0/0 -
1 TTY - inout - - - 0 0 0/0 -
2 TTY - inout - - - 0 0 0/0 -
3 TTY - inout - - - 0 0 0/0 -
4 TTY - inout - - - 0 0 0/0 -
5 TTY - inout - - - 0 0 0/0 -
6 TTY - inout - - - 0 0 0/0 -
7 TTY - inout - - - 0 0 0/0 -
8 TTY - inout - - - 0 0 0/0 -
9 TTY - inout - - - 0 0 0/0 -
10 TTY - inout - - - 0 0 0/0 -
. . .
Snip
Step 3
(Optional) Choose a specific line and inspect the modem-to-TTY association. In this example, TTY 1
is associated with modem 1/0. The modem state is idle because no users have dialed in yet.
5300-NAS#show line 1
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
1 TTY - inout - - - 0 0 0/0 -
Line 1, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Status: No Exit Banner
Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out
Modem Callout, Modem RI is CD, Integrated Modem
Modem state: Idle
modem(slot/port)=1/0, state=IDLE
dsx1(slot/unit/channel)=NONE, status=VDEV_STATUS_UNLOCKED
Modem hardware state: CTS noDSR DTR noRTS
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:10:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are pad telnet rlogin udptn v120 lapb-ta. Preferred is pad t
elnet rlogin udptn v120 lapb-ta.
No output characters are padded
No special data dispatching characters
5300-NAS#