User`s guide

19-51
Cisco Router and Security Device Manager Version 2.2 User’s Guide
OL-4015-08
Chapter 19 Intrusion Prevention System
Global Settings
Determine Which SDF File is in Memory
To determine which SDF file is in router memory, open a Telnet session to the
router, and enter the show flash command. The output will be similar to the
following:
System flash directory:
File Length Name/status
1 10895320 c1710-k9o3sy-mz.123-8.T.bin
2 1187840 ips.tar
3 252103 attack-drop.sdf
4 1038 home.shtml
5 1814 sdmconfig-1710.cfg
6 113152 home.tar
7 758272 es.tar
8 818176 common.tar
[14028232 bytes used, 2486836 available, 16515068 total]
16384K bytes of processor board System flash (Read/Write)
In this example the file attack-drop.sdf is in router memory. On some routers, such
as routers with a disk file system, you use the dir command to display the contents
of router memory.
Configuring IPS to Use an SDF
To have IPS use the SDF in router memory, do the following:
Step 1 Click Global Settings.
Step 2 In the Configured SDF locations list, click Add.
Step 3 In the dialog box displayed, click Specify SDF on flash, and enter the name of
the SDF file.
Step 4 Click OK to close the dialog box.
Global Settings
Edit Button
Click to edit any of the global settings seen in this window.