User`s guide

5-15
Cisco Router and Security Device Manager Version 2.2 User’s Guide
OL-4015-08
Chapter 5 Create Firewall
How Do I...
access-list 105 permit udp host 123.3.4.5 host 192.168.0.1 eq isakmp
access-list 105 permit udp host 123.3.4.5 host 192.168.0.1 eq
non500-isakmp
How Do I Permit Specific Traffic Through a DMZ Interface?
Follow the steps below to configure access through your firewall to a web server
on a DMZ network:
Step 1 From the left frame, select Firewall and ACL.
Step 2 Select Advanced Firewall.
Step 3 Click Launch the Selected Task.
Step 4 Click Next.
The Advanced Firewall Interface Configuration screen appears.
Step 5 In the Interface table, select which interfaces connect to networks inside your
firewall and which interfaces connect to networks outside the firewall.
Step 6 From the DMZ Interface field, select the interface that connects to your DMZ
network.
Step 7 Click Next>.
Step 8 In the IP Address field, enter the IP address or range of IP addresses of your web
server(s).
Step 9 From the Service field, select TCP.
Step 10 In the Port field, enter 80 or www.
Step 11 Click Next>.
Step 12 Click Finish.