Troubleshooting guide

9-38
Cisco Broadband Local Integrated Services Solution Troubleshooting Guide
OL-5169-01
Chapter 9 Troubleshooting Cisco Media Gateways
Symptoms and Solutions
Use the PXM dspsmcnf command to identify a T1/E1 configuration mismatch, as follows:
NODENAME.1.7.PXM.a > dspsmcnf
slot Card Rate Channel MIB Feature
No. Type Control ized IMA MULTRKS Version Bits
------ ---------- ------- ------- ------- ------- ------- -------
1 ------> No configuration file exist for this slot <------
2 ------> No configuration file exist for this slot <------
3 VISM-8T1 Off Off Off Off 20 0x0
4 ------> No configuration file exist for this slot <------
5 VISM-8T1 Off Off Off Off 20 0x0
6 ------> No configuration file exist for this slot <------
9 ------> No configuration file exist for this slot <------
10 ------> No configuration file exist for this slot <------
11 ------> No configuration file exist for this slot <------
12 ------> No configuration file exist for this slot <------
13 ------> No configuration file exist for this slot <------
14 ------> No configuration file exist for this slot <------
17 ------> No configuration file exist for this slot <------
18 ------> No configuration file exist for this slot <------
19 ------> No configuration file exist for this slot <------
20 ------> No configuration file exist for this slot <------
21 ------> No configuration file exist for this slot <------
22 ------> No configuration file exist for this slot <------
25 ------> No configuration file exist for this slot <------
26 ------> No configuration file exist for this slot <------
27 ------> No configuration file exist for this slot <------
28 ------> No configuration file exist for this slot <------
29 ------> No configuration file exist for this slot <------
30 ------> No configuration file exist for this slot <------
Use the PXM dsplog command to show a card mismatch log entry, logged by VISM card on slot 5, as
follows:
09/09/2001-00:01:47 05 dsplog VISM-6-9025
VISM going to standby : Config. Mismatch between PXM and VISM
Use the VISM dspcd command to display the following information:
NODENAME.1.5.VISM8.s > dspcd
ModuleSlotNumber: 5
FunctionModuleState: Mismatch
FunctionModuleType: VISM-8E1
FunctionModuleSerialNum: CAB12345678
FunctionModuleHWRev: 0.13
FunctionModuleFWRev: 2.2.10g.pm
FunctionModuleResetReason: WatchDog timeout reset
LineModuleType: Missing
LineModuleState: Not Present
mibVersionNumber: 20
configChangeTypeBitMap: CardCnfChng, LineCnfChng
cardIntegratedAlarm: Clear
pcb part no - (800 level): 800-03530-01
pcb part no - (73 level): 73-03021-01
Fab Part no - (28 level): 28-02492-01
PCB Revision: 01
Daughter Card Information:
Daughter Card Serial Number: CAB12345678
pcb part no - (73 level): 73-03022-01
Fab Part no - (28 level): 28-02493-01
PCB Revision: 01 value = 34 = 0x22 = ’"’