Troubleshooting guide

9-4

Cisco Broadband Local Integrated Services Solution Troubleshooting Guide

OL-5169-01

Chapter 9 Troubleshooting Cisco Media Gateways

Command Line Interface

The PXM45 system diagnostics CLI provides the ability to configure diagnostics, to initiate the On-line

or Off-line diagnostics, and to display diagnostics status. The commands are described in the following

paragraphs:

Note All parameters are required unless specifically labeled (optional).

cnfdiag This command configures diagnostics. When this command is entered without any parameters, it will

display the current configuration and status.

cnfdiag <slot> <onEnb> <offEnb> [<offCover> <offStart> <offDow>]

Parameters:

• slot—Specifies physical slot number. The value is from 1 to MAX_SLOTS.

• onEnb—Indicates whether to enable or disable online diagnostics on this slot.

• offEnb—Indicates whether to enable or disable offline diagnostics on this slot.

• offCover—(optional) Specifies how much test coverage the offline diagnostics should perform. The

coverage is defined as light, medium, and full. The light tests are less than 5 minutes, the medium

tests are less than 30 minutes, and full is unlimited. Since the tests are card, please refer to

diagnostics functional specification on each card for the type of tests are being performed for each

coverage.

• offStart—(optional) Specifies the start time of the offline diagnostics. This option has a format --

HH:MM, e.g. 03:45 or 22:15.

• offDow—(optional) Specifies the start day of week for the offline diagnostics. This option has a

format -- SMTWTFS, e.g. monday and wednesday -M-W----.

abortofflinediag This command aborts running offline diagnostics

abortofflinediag <slot>

Parameters

slot—Specifies the physical slot number. The value is from 1 to MAX_SLOTS.

clrdiagerr This command clears diagnostics errors.

clrdiagerr <slot>

Parameters

slot—Specifies the physical slot number. The value is from 1 to MAX_SLOTS.