Troubleshooting guide

3-31
Cisco Broadband Local Integrated Services Solution Troubleshooting Guide
OL-5169-01
Chapter 3 Trouble Isolation Procedures
Component States
Equip Command
The equip command changes the administrative state of terminations that are in the UEQP state to the
OOS state. It ignores the terminations in the INS, MAINT, or OOS states.
Use the equip command or the control trunk-grp command to change the termination state for a
subscriber to a trunk. The control trunk-grp command changes all trunks in the specified trunk group to
the specified state. Use the equip command to set the subscriber termination state. Thereafter, to change
the termination state, use the control command.
A subscriber termination state must set to unequipped before it can be deleted.
You cannot use the control command to change a termination state to UEQP. Furthermore, you cannot
use the control command to change the state of any subscriber termination that is already in the UEQP
state.
For example, consider a case in which 24 CICs in a trunk group are in the following initial states:
• CICs 1–10 in OOS state
• 11–15 in UEQP state
• 16–24 in MAINT state
For this case, issuing the control, equip, or unequip commands would affect the initial state of the CICs
as follows:
• If a control command is used with target-state = ins, the final states of all the CICs are:
– CICs 1–10 in INS state
– CICs 11–15 in UEQP state
– CICs 16–24 in INS state
• If a equip command is applied to the CICs in the initial states, the final states of all the CICs are:
– CICs 1–10 in OOS state
– CICs 11–15 in OOS state
– CICs 16–24 in MAINT state
• If an unequip command is applied to the CICs in the initial states, the final states of the CICs are:
– CICs 1–10 in UEQP state
– CICs 11–15 in UEQP state
– CICs 16–24 in MAINT state
Use the following example to equip a trunk termination:
CLI> equip trunk-termination tgn-id=13; cic=all;
Reply : Success: CLI change successful
TGN ID -> 13
REASON -> ADM executed successful
RESULT -> ADM configure result in success
CIC START -> 1
CIC END -> 24
FAIL REASON -> ADM found no failure