Troubleshooting guide

3-29

Cisco Broadband Local Integrated Services Solution Troubleshooting Guide

OL-5169-01

Chapter 3 Trouble Isolation Procedures

Component States

Control Command

This section describes how to control trunk terminations. The section is organized as follows:

• Control One Trunk Termination

• Control All Trunk Terminations

Control One Trunk Termination

Use the following example to control one trunk termination into OOS:

CLI> control trunk-termination tgn-id=22; cic=1; target-state=OOS; mode=forced;

Reply : Success: CLI change successful

TGN ID -> 22

REASON -> ADM executed successful

RESULT -> ADM configure result in success

CIC START -> 1

CIC END -> 1

FAIL REASON -> ADM found no failure

REQUEST STATE -> ADMIN_OOS

RESULT STATE -> ADMIN_OOS

Control All Trunk Terminations

Use the following example to control all trunk terminations for a particular CIC group to OOS:

CLI> control trunk-termination tgn-id=17; cic=1-23; target-state=oos;

mode=forced;

Reply: Request was successful.