Troubleshooting guide

3-22
Cisco Broadband Local Integrated Services Solution Troubleshooting Guide
OL-5169-01
Chapter 3 Trouble Isolation Procedures
Component States
• Trunk group restore establish request maintenance
• Trunk group restore establish fail normal
• Trunk group restore establish fail switch-over
• Trunk group restore establish fail maintenance
• Trunk group in maintenance state
• Trunk group down session set fail soft normal
• Trunk group down session set fail hard normal
• Trunk group down session set fail soft maintenance
• Trunk group down session set fail hard maintenance
• Trunk group down establish request soft normal
• Trunk group down establish request hard normal
• Trunk group down establish request soft maintenance
• Trunk group down establish request hard maintenance
• Trunk group down establish fail soft normal
• Trunk group down establish fail hard normal
• Trunk group down establish fail soft maintenance
• Trunk group down establish fail hard maintenance
• Trunk group delete graceful
• Trunk group request remove release
• Trunk group request remove session set
• Trunk group remove graceful in-service and maintenance state
• DPC is inaccessible
Control Command
The following example controls a single trunk group ID into service:
CLI> control trunk-grp id=2; mode=forced; target-state=INS;
Reply : Success: CLI change successful
INITIAL STATE -> ADMIN_OOS
REQUEST STATE -> ADMIN_INS
RESULT STATE -> ADMIN_INS
FAIL REASON -> ADM found no failure
REASON -> ADM executed successful
RESULT -> ADM configure result in success
TGN ID -> 2
Note When performing the following commands in succession, wait at least one second between commands:
control trunk-grp tgn-id=129; mode=forced; target-state=oos;
control trunk-grp tgn-id=129; mode=forced; target-state=ins;