Troubleshooting guide

3-17
Cisco Broadband Local Integrated Services Solution Troubleshooting Guide
OL-5169-01
Chapter 3 Trouble Isolation Procedures
Component States
Status Command
This section describes how to show the status of subscriber terminations. It is organized as follows:
• Single Subscriber Termination Status
• All Subscriber Terminations Status
• Administrative State Token
• Operating State Token
• Source Token
Single Subscriber Termination Status
The following example checks the status of a single subscriber termination:
CLI> status subscriber-termination id=ubr204_1;
RESULT -> ADM configure result in success
REASON -> ADM executed successful
ADMIN STATE -> ADMIN_INS
OPER STATE -> Termination is idle
SUBCRIBER DN -> ubr204_1
FAULT REASON -> No fault reason available
The administrative states the system can return are as follows:
• ADMIN-UEQP—Unequipped.
• ADMIN-INS—In Service.
• ADMIN-OOS—Out of Service.
• ADMIN-MAINT—Maintenance Mode.
• ADMIN-OOS-PENDING—Transitioning to Out of Service.
• ADMIN-MAINT-PENDING—Transitioning to Maintenance Mode.
All Subscriber Terminations Status
The following example shows the status of all subscriber-terminations on a particular gateway:
CLI> status subscriber-termination id=*@ubr235;
Reply : Success:
SUBCRIBER DN -> ubr235_1
ADMIN STATE -> ADMIN_UEQP
OPER STATE -> Termination is unequiped
REASON -> ADM executed successful
RESULT -> ADM configure result in success
FAULT REASON -> No fault reason available
SUBCRIBER DN -> ubr235_2
ADMIN STATE -> ADMIN_UEQP
OPER STATE -> Termination is unequiped
REASON -> ADM executed successful
RESULT -> ADM configure result in success
FAULT REASON -> No fault reason available