Specifications

Chapter 2 Managing the GSS from the CLI
Restarting the GSS Software
2-20
Cisco Global Site Selector Administration Guide
OL-5480-01
Restarting the GSS Software
To perform a warm restart of the GSS software, use the gss restart command.
Before you perform a warm restart of the GSS software, save your recent GSS
configuration changes to memory. Use the copy running-config startup-config
CLI command to save your configuration changes. If you fail to save your
configuration changes, the GSS device reverts to its previous settings upon a
reboot.
To perform a warm restart of the GSS, enter:
gssm1.example.com# gss restart
As the GSS reboots, output appears on the console terminal.
Performing a Cold Restart of a GSS Device
To halt GSS operation and perform a cold restart of your GSS device, use the
reload command. The reload command reboots the GSS device and performs a
full power cycle of both the GSS hardware and software. Any open connections
with the GSS are dropped after you enter the reload command.
Before you perform a cold restart of GSS, save your recent GSS configuration
changes to memory. Use the copy running-config startup-config CLI command
to save your configuration changes. If you fail to save your configuration changes,
the GSS device reverts to its previous settings upon restart.
To halt and perform a cold restart of the GSS, enter:
gssm1.example.com# reload
As the GSS boots, output appears on the console terminal.