Specifications

Appendix A Upgrading the GSS Software
A-6
Cisco Global Site Selector Administration Guide
OL-5480-01
230 User admin logged in. Access restrictions apply.
Remote system type is UNIX.
Using ascii mode to transfer files.
ftp> binary
ftp> get
(remote-file) gss.upg
(local-file) gss.upg
local: gss.upg remote: gss.upg
200 PORT command successful.
...
3. Enable privileged EXEC mode.
gssm1.example.com> enable
gssm1.example.com#
4. Enter the gss stop command to stop the GSS software.
gssm1.example.com# gss stop
5. Enter the install command to install the upgrade.
gssm1.example.com# install gss.upg
6. At the Proceed with install (the device will reboot)? (y/n): prompt, type y to
reboot the GSS device. After the GSS reboots, you lose any network CLI
connections. Console connections remain active.
Note If you did not previously save changes to the startup-config file, the Save
current configuration? [y/n]: prompt appears. At the prompt, type y to
continue. The GSS then reboots.
7. After the GSS device reboots, log in to the GSS device and enable privileged
EXEC mode.
8. Enter the gss status command and verify that the GSS device reaches a
normal operation state of runmode 4 or 5.
9. Repeat this procedure for the remaining GSS devices in your network.