Specifications
1406
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(27)S
–
Delete subinterface.
–
Create another subinterface.
–
Create the first subinterface again.
Conditions: This symptom is observed on a Cisco 7500 series router that is running Cisco IOS
Release 12.0 S or Release 12.2 S.
Workaround: There is no workaround. Reload to clear the condition.
• CSCec76078
Symptoms: A 4-port OC-3 ATM line card may reload within a few minutes.
Conditions: This symptom is observed on a 4-port OC-3 ATM line card with several ports connected
but without the Tx clocks being synchronized on the ports.
Workaround: Synchronize all Tx clocks, or disconnect the ports.
• CSCec77576
Symptoms: The following error messages may be displayed on a Cisco router when the show ip cef
inconsistency now EXEC command is entered:
Error: Time-out waiting for linecards ( 0 1 2 3 4 9 ) to respond.
Error: Failed to run full-scan-rp checker
The (0 1 2 3 4 9) listing in the error message refers to the populated slots in the router.
Conditions: This symptom is observed on a Cisco 7500 series router after a Stateful Switchover
(SSO) has occurred.
Workaround: There is no workaround.
• CSCec77699
Symptoms: In a Fast Software Upgrade (FSU) and software downgrade test environment, a standby
Performance Routing Engine (PRE) may reload.
Conditions: This symptom is observed on a Cisco router when an FSU downgrade from Cisco IOS
Release 12.0(26)S to Release 12.0(23)S4 or Release 12.0(24)S3 occurs.
Workaround: Reboot the router.
• CSCec80049
Symptoms: When a tunnel interface goes down, a new Label Switched Path (LSP) is not signaled
until the forwarding adjacency hold timer expires.
Conditions: This symptom is observed on a Cisco router that is configured with Multiprotocol Label
Switching (MPLS) traffic engineering (TE) tunnels.
Workaround: There is no workaround.
• CSCec86963
Symptoms: A Versatile Interface Processor (VIP) may reload and cause the Route Switch Processor
(RSP) to reload after an input set policy is added to a Frame Relay (FR) map class.
Conditions: This symptom is observed on a Cisco 7500 series router.
Workaround: Use traffic policing to set the input policy.