Specifications
1405
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(27)S
• CSCec68831
Symptoms: When a router boots up with an existing policy map, the quality of service (QoS)
marking function may not function correctly depending upon the combination of line cards that are
in the router. The symptom is observed more often with channelized port adapters.
Conditions: This symptom has been observed on a Cisco 7500 series router with many channelized
port adapter when the policy is applied to the input direction of the interface.
Workaround: After the router boots up, recreate the new policy map and apply it to the input
direction of the channelized interface.
• CSCec69392
Symptoms: The Forwarding Information Base (FIB) may be disabled on various types of line cards.
Conditions: This symptom is observed on a Cisco 12000 series after you have performed an online
insertion and removal (OIR) of the clock scheduler card (CSC).
Workaround: There is no workaround.
• CSCec69756
Symptoms: You may not be able to configure the maximum transmission unit (MTU) on a virtual
template.
Conditions: This symptom is platform independent.
Workaround: There is no workaround.
• CSCec69982
Symptoms: You may not be able to reestablish a direct label distribution protocol (LDP) session over
an Any transport over MPLS (AToM) virtual circuit (VC).
Conditions: This symptom is observed on a Cisco router when the mpls ip interface configuration
command is not enabled on any interface and when you delete and reenter the xconnect AT M VC
configuration command in quick succession.
Workaround: Remove the AToM VC, delete and reenter the xconnect interface configuration
command, wait until the router returns to the prompt, and recreate the AToM VC.
• CSCec70301
Symptoms: The output queue of an 8-port multichannel T1/E1 PRI port adapter (PA-MC-8TE1+)
may be stuck, even though the controller is up.
Conditions: This symptom is observed on a Cisco router that runs Cisco IOS Release 12.0 S,
Release 12.1 E, or Release 12.2 S after you have performed an online insertion and removal (OIR)
of the PA-MC-8TE1+.
Workaround: Reload the router.
• CSCec73093
Symptoms: NetFlow export may not function when a service policy is enabled.
Conditions: This symptom is observed on a Fast Ethernet interface that has 802.1q encapsulation
enabled.
Workaround: There is no workaround.
• CSCec75189
Symptoms: Two interfaces may have the same Cisco Express Forwarding (CEF) interface
description block (IDB) when the following configuration sequence occurs:
–
Create subinterface.