Specifications

1365
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(27)S
Conditions: This symptom is observed on a Cisco 7500 series router when Multilink PPP (MLP) is
configured on the serial interface and distributed Cisco Express Forwarding (dCEF) switching is
enabled.
Workaround: There is no workaround.
• CSCea66198
Symptoms: A Cisco 7500 series router may encounter a bus error when applying a crypto map on
an FDDI interface.
Conditions: This symptom is observed on a Cisco 7500 series router that is running Cisco IOS
Release 12.2(11)T2, Release 12.2(13)T1, or Release 12.2(13a). The symptom may also occur in
other releases such as Release 12.0 S.
Workaround: There is no workaround.
• CSCeb38393
Symptoms: A Cisco 7500 series may generate the following message on its console:
%VIP-3-BADMALUCMD: Unsupported MALU command 81/82
Conditions: This symptom is observed on a Cisco 7500 series that runs Cisco IOS
Release 12.0(23)S1.
Workaround: There is no workaround.
• CSCeb59227
Symptoms: The ifOutUcastPkts, ifOutOctets, and ifHCOutOctets Simple Network Management
Protocol (SNMP) counters of a Fast Ethernet subinterface may not be incremented.
Conditions: This symptom is observed on a Cisco 7500 series when traffic is received from a serial
interface in a Multiprotocol Label Switching (MPLS) network and when the Fast Ethernet
subinterface is configured for dot1q encapsulation.
Workaround: There is no workaround.
• CSCec26643
Symptoms: Packet-over-SONET (POS) interfaces on a 1-port POS OC-3c/STM-1 port adapter
(PA-POS-OC3) that is installed in a Cisco 7200 series router that runs Cisco IOS
Release 12.2(14)S3 may stop transmitting packets. The output packets counter stops incrementing.
Conditions: This symptom is observed when you reload the router with a queueing configuration on
the POS interfaces.
Workaround: Remove the queueing configuration before you reload the router. Reapply the
queueing configuration after the router has booted up.
• CSCec79579
Symptoms: A FlexWAN module may reload unexpectedly while the switch or router boots up and
brings up the modules and port adapters.
Conditions: This symptom is observed when a 1-port T3 serial port adapter (PA-T3) is installed in
the FlexWAN module.
Workaround: There is no workaround.
• CSCin38177
Symptoms: When a router boots up, a FlexWAN module that is configured with a serial T3 port
adapter may come up and may reload immediately.
Conditions: This symptom is observed on a Cisco Catalyst 6000 series or Cisco 7600 series.