Specifications

1063
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(29)S
• CSCin73703
Symptoms: A router may crash when you enter the set fr-fecn-becn command.
Conditions: This symptom is observed when you enter the set fr-fecn-becn command for an
unsupported interface (that is, a non-Frame Relay interface).
Workaround: There is no workaround.
• CSCin74920
Symptoms: A spurious memory access may occur when a VC class with OAM parameters is created.
Conditions: This symptom is observed on a Cisco router that runs Cisco IOS Release 12.0S.
Workaround: There is no workaround.
• CSCin76900
Symptoms: A PA-A3-8T1IMA or PA-A3-8E1IMA port adapter that is installed in a Cisco 7xxx
series may display an increasing “rx_no_buffer” counter in the output of the show controllers atm
privileged EXEC command, and some PVCs that are configured on the port adapter may stop
receiving traffic.
Conditions: This symptom is observed when there is a high-traffic load on the PA-A3-8T1IMA or
PA-A3-8E1IMA port adapter.
Workaround: Enter the shutdown interface configuration command followed by the no shutdown
interface configuration command on the PA-A3-8T1IMA or PA-A3-8E1IMA port adapter, or as an
alternate workaround, reset the VIP or FlexWAN.
• CSCin77221
Symptoms: You can configure color-aware policing classes by entering the match-fr-dlci command
but the command does not have any effect. The match-fr-de command works fine.
Conditions: This symptom is observed when you configure color-aware policing on an edge
interface of a PE router.
Workaround: There is no workaround.
• CSCuk51177
Symptoms: You may not be able to make a Telnet connection to a Cisco IOS platform.
Conditions: This symptom is observed when the CNS Exec Agent is used to remotely issue an
interactive CLI command.
Workaround: There is no workaround.
• CSCuk51269
Symptoms: Multicast packets such as HSRP and OSPF are not received on a port-channel interface.
Conditions: This symptom is observed when a port-channel interface is configured on a
Cisco router, when you reload the router, and when the first member is added to the port-channel
interface by entering the no shutdown interface configuration command on physical interface.
Workaround: Enter the do shutdown interface configuration command followed by the no
shutdown interface configuration command on the port-channel interface.