Specifications

1290
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(27)S4
• CSCeg03180
Symptoms: A line card in slot 15 is stuck in the WAITRTRY state.
Conditions: This symptom is observed on a Cisco 12816 that is configured with dual RPs when an
RP switchover followed by a CSC switchover occurs.
Workaround: Reload the router.
Alternate Workaround: Power down and power up the router.
• CSCeg06618
Symptoms: A 6-port channelized T3 line card and a 2-port Channelized OC-3 line card may
continuously generate the following error message:
%LC_CX3-2-PLIM_CPU_CRASHED: PLIM CPU Tofab755 - plim reset
Controllers and interfaces do not recover.
Conditions: This symptom is observed on a Cisco 12000 series and occurs because of a problem with
the recovery mechanism following a forced reset of the PLIM component of the line card. The
symptom is visible only if another problem indirectly triggers a forced reset of the PLIM
component.
Workaround: There is no workaround. To recover the affected line card, reload the line card by
entering hw-module slot slot-number reload command.
• CSCeg10642
Symptoms: When six queues are configured on an interface and some of the queues do not have
traffic, the bandwidth of those inactive queues should be given to other active queues (queues with
traffic) in proportion to their EIR (configured via bandwidth remaining). However, this is not the
case. The bandwidth is not proportionally given to all the queues.
Conditions: This symptom occurs when configuring a policy map that creates six queues in an
interface.
Workaround: There is no workaround.
• CSCeg11421
Symptoms: A Cisco 10720 crashes when you delete an IPv6 ACL.
Conditions: This symptom is observed when you delete the IPv6 ACL during the TurboACL
compilation.
Workaround: Wait for the ACL to be fully compiled before you delete it.
• CSCeg13868
Symptoms: When the no tag-switching ip propagate-ttl command is configured on PE routers and
a traceroute is executed from one CE router to a remote CE router, an egress PE router replies to the
traceroute with the address of its ingress MPLS interface.
Conditions: This symptom is observed only when the traceroute is destined for a network between
an egress PE router and a remote CE router, when the ingress line card of the egress PE router is a
Cisco 12000 series Engine 0 or Engine 1 line card.
Workaround: There is no workaround.
• CSCeg16631
Symptoms: When you enter the distribute-list interface command in a global RIP routing context
and the interface that is specified in the command is a VRF interface, the command is rejected with
the following error message:
% The interface is not in the same VRF as the process