Specifications

1258
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(27)S5
-Process= "cpf_process_ipcQ", ipl= 0, pid= 141
-Traceback= 603DDCB0 603E005C 60B5BE50 60B5C140 60B5C62C 60B59A0C 603D5D1C
603D5D08
%SYS-2-MALLOCFAIL: Memory allocation of 344820739 bytes failed from
0x60B5BE48, alignment 0
Pool: Processor Free: 363937412 Cause: Memory fragmentation
Alternate Pool: None Free: 0 Cause: No Alternate pool
-Process= "cpf_process_ipcQ", ipl= 0, pid= 141
-Traceback= 603DDCB0 603E005C 60B5BE50 60B5C140 60B5C62C 60B59A0C 603D5D1C
603D5D08
Conditions: This symptom is observed on a Cisco 10000 series that runs Cisco IOS
Release 12.0(24)S5.
Workaround: There is no workaround.
• CSCef06848
Symptoms: Packets are not load-balanced between interfaces of different POS line cards or POS port
adapters.
Conditions: This symptom is observed on a Cisco router that runs Cisco IOS Release 12.0(25)S or
Release 12.0(26)S2 and that has two BGP peers. Four static routes are configured on interfaces of
one POS line card or POS port adapter to the loopback IP address of one BGP peer and another four
static routes are configured on interfaces of another POS line card or POS port adapter to the
loopback IP address of the other BGP peer.
In this configuration, 85 percent of the traffic runs via the output interfaces on one POS line card or
POS port adapter. When you enter the The clear adjacency command, 85 percent of the traffic runs
via the output interfaces on the other POS line card or POS port adapter.
Workaround: There is no workaround.
• CSCef20602
Symptoms: A static route to a default route that points at a non-directly connected next hop (a
recursive route) may not be properly downloaded to the hardware CEF entry on an Engine 6 line
card.
Conditions: This symptom is observed on a Cisco 12000 series.
Workaround: Configure the default route to point to a directly-connected next hop.
• CSCef23912
Symptoms: A traceback is generated on the console and logged in the logging buffer, and the count
in the output of the show alignment command increments.
Conditions: This symptom is observed on a Cisco 10000 series that is configured as a provider edge
(PE) router when you enter the show mpls forwarding command to show the pop labels and the
active LDP peers.
Workaround: There is no workaround.
• CSCef25686
Symptoms: A number of PVCs may become locked in an inactive state, and the following type of
error message may appear in the log:
%ATM-3-FAILREMOVEVC: ATM failed to remove VC(VCD=X, VPI=X, VCI=X) on Interface
ATM X/X/X,