Specifications

1051
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(29)S
• CSCed92837
Symptoms: After a Stateful Switchover (SSO) occurs on a Cisco 7500 series, the standby Route
Switch Processor (RSP) my hang just before downloading the image. This situation may prevent the
router from entering the STANDBY-HOT state and from being capable to perform a switchover until
the standby RSP is reset.
Conditions: This symptom is observed on Cisco 7500 series that runs Cisco IOS Release 12.0 S or
12.2 S and that is configured for SSO/Nonstop Forwarding (NSF).
Workaround: There is no workaround. After the problem occurs, you can recover the router by either
waiting for an IPC timer to expire (the default time is 30 minutes) or by entering the hw-module
sec-cpu reset command.
• CSCed93593
Symptoms: The cisco.mgmt.cns.config-changed event message contains invalid changeItem
information.
Example: for: (config)#policy-map TEST2
(config-pmap)#class m_new
(config-pmap-c)#shape peak 8010
(config-pmap-c)#priority
(config-pmap-c)#exit
(config-pmap)#desc TESTTEST
(config-pmap)#exit
The 4th changeItem is: Context: <empty>
EnteredCmd: exit
NewConfig#: <empty>
OldConfig#:
!
MyPolicy
test
TEST2
description TESTTEST
class m_new
shape peak 8010
priority
The above-mentioned changeItem information is incorrect.
Conditions: This may occur when the CNS configuration notify agent is configured by the cns
config notify command and a policy-map CLI is configured on the Cisco IOS device.
Workaround: There is no workaround.
• CSCee00661
Symptoms: Changing any IP access control list (ACL) may cause a walk of all LC-ATM prefixes.
Conditions: This symptom is observed on a router configured with an LC-ATM Multi-VC when the
changed ACL is not related to the Multi-VC.
Workaround: There is no workaround.
• CSCee01931
Symptoms: A router may crash when you enter the fair-queue command on the interface of a
PA-MC-STM-1 port adapter.