Specifications

1165
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(28)S1
NewConfig#: <empty>
OldConfig#:
!
MyPolicy
test
TEST2
description TESTTEST
class m_new
shape peak 8010
priority
Conditions: This may occur when the CNS configuration notify agent is configured by the cns
config notify configuration command and policy-map CLI is configured on the Cisco IOS device.
Workaround: There is no workaround.
• CSCed95753
Symptoms: A GRE tunnel may not work on a PE router.
Conditions: This symptom is observed on a Cisco 12000 series that runs the gsr-p-mz image of
Cisco IOS Release 12.0(25)S or a later release.
Workaround: There is no workaround.
• CSCee01931
Symptoms: A router may crash when you enter the fair-queue command on the interface of a
PA-MC-STM-1 port adapter.
Conditions: This symptom is observed on a Cisco router that runs Cisco IOS Release 12.0 S when
the interface has the rate-limit output command enabled.
Workaround: There is no workaround.
• CSCee04454
Symptoms: A Cisco 10000 series router reloads unexpectedly as ATM VCs are coming up.
Conditions: This symptom is believed to occur only when ACLs are applied on ATM interfaces, and,
only rarely then, on images that contain the CSCed72686 fix.
Workaround: There is no workaround.
• CSCee13932
Symptoms: Cisco target FEC stack TLVs may not interoperate with those of third-party vendors.
Conditions: This symptom is observed on a Cisco platform that runs Cisco IOS Release 12.0(27)S
or Release 12.0(28)S.
Workaround: There is no workaround.
• CSCee14817
Symptoms: HSRP over the VRF is not working after following these steps:
1. PE router 1 is the active HSRP router and a redundancy forced switchover occurs on PE router 2
(standby HSRP VPN) with SSO configured.
2. You enter the shutdown command on the GE subinterface of PE router 1.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(25)S3, that has a PRP and 4-port GE ISE line cards, and that functions as a PE router.
Workaround: Enter the standby use-bia command or use RPR+ instead of SSO.