Specifications

1159
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(28)S1
Condition 1: This symptom is observed when you configure the CNS cns config notify diff
global configuration command and you configure interface global configuration commands on
the Cisco IOS device.
Workaround 1: There is no workaround if only the changes in the configuration are expected in
the CNS configuration notify changed message.
Alternate Workaround 1: Specify the all option for the cns config notify global configuration
command.
2. Symptom 2: Once the cns config notify global configuration command is configured, the router
may not detect a newly created interface.
Condition 2: This symptom is observed when the diff option in the cns config notify global
configuration command is selected and a new dynamic interface is created.
Workaround 2: There is no workaround.
• CSCec11645
Symptoms: VIP crashes with DMA Receive error.
Conditions: This symptom can occur when doing xconnect hairpinning of two interfaces on the same
VIP.
Workaround: There is no workaround.
• CSCec15517
Symptoms: A Cisco router may reload when you enter the show policy-map interface command in
one router session while deleting the sub-interface on which the policy is attached from another
session.
Conditions: This symptom is observed on a Cisco 7500 series that is configured with a Frame Relay
permanent virtual circuit (PVC) policy.
Workaround: There is no workaround.
• CSCec77049
Symptoms: The adjacency table is not retained after an RP switchover.
Conditions: This symptom occurs with a 4-port Ethernet PA inside a VIP4-80 on an RSP 16.
Workaround: Clear the adjacency table with the clear adjacency command after the Stateful
Switchover (SSO).
• CSCec82589
Symptoms: After entering a no hw-module slot command on the primary CSC, an Engine 0 OC-12
(channelized to DS3) line card may be come inoperable.
Conditions: This symptom is observed on a Cisco 12416 router that is running the gsr-p-mz image
of Cisco IOS Release 12.0(24)S.
Workaround: Use the microcode reload global configuration command to reload the line card.
• CSCec87006
Symptoms: A Multilink PPP (MLP) interface on an Engine 3 CHoC12/T1 line card fails to accept
an MQC policy that has a police CIR rate of more than 1536000 bps on the priority queue, even when
the MLP interface has a bandwidth of 12288 kbps.
Conditions: This symptom is observed on a Cisco 12000 series router.
Workaround: There is no workaround.