Specifications

1146
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(28)S2
Conditions: This symptom is observed on a Cisco 12000 series that runs an interim release for
Cisco IOS Release 12.0(30)S after you configure IP QoS on an ATM interface of the line card. Note,
however, that this caveat is resolved in Release 12.0(30)S.
Workaround: There is no workaround.
Wide-Area Networking
• CSCef45502
Symptoms: A connection remains to exist on a line card even though the connection is deleted on
the RP.
Conditions: This symptom is observed on a Cisco 12000 series when you enter the no frame-relay
interface-dlci command.
Workaround: Enter the shutdown command followed by the no shutdown command on the affected
interface.
• CSCef77523
Symptoms: The protocol may go down on random Multilink Frame Relay (MFR) link bundles.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(28)S and that is configured with a 1-port channelized OC-12/STM-4 (DS1/E1) ISE
line card after you have reloaded the router. The symptom may also occur in other releases such as
Release 12.2S and Release 12.3.
Workaround: Enter the shutdown interface configuration command followed by the no shutdown
interface configuration command on the affected interface.
• CSCef82683
Symptoms: An MFR bundle may stay in the down state after redistributing bundle links. The output
of the show frame-relay multilink command displays as cause code “inconsistent bundle.”
Conditions: This symptom is observed when a Remove-Link message is lost.
Workaround: Enter the shutdown command followed by the no shutdown command on the affected
bundle.
• CSCin05330
Symptoms: When a multilink bundle interface is created by entering the interface multilink
group-name global configuration command, the Cisco Discovery Protocol (CDP) becomes
incorrectly disabled. If the cdp enable interface configuration command is used to enable CDP on
the multilink bundle interface, the command is not saved in the startup configuration and CDP
remains disabled after the router is reloaded.
Conditions: This symptom is observed on a Cisco platform that is configured with a multilink bundle
interface.
Workaround: There is no workaround.