Specifications
1141
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(28)S2
• CSCeg00111
Symptoms: Padded IP fragments with an IP length that is shorter than 64 bytes and the More
Fragments (MF) (which is set to 1) are dropped by an Engine 4+ line card that functions as an egress
line card.
Conditions: This symptom is observed when the ingress line card is an Engine 4+ DPT line card and
the egress line card is any Engine 4+ line card.
Workaround: There is no workaround.
• CSCeg00252
Symptoms: When you enter the show sec-disk0: command or the execute-on slot slot-number
command command on the standby RP, no command output is generated.
Conditions: This symptom is observed on a Cisco 12000 series that has dual RPs and that is
configured for RPR, RPR+, or SSO redundancy mode. Note that when you enter the dir sec-disk0:
command on the standby RP, command output is properly generated.
Workaround: There is no workaround.
• CSCeg00338
Symptoms: A high CPU utilization may occur at the interrupt level on a Cisco 10000 series when
CLNS traffic is forwarded.
Conditions: This symptom is observed on a Cisco 10000 series that is configured with an PRE-1 and
that runs Cisco IOS Release 12.0(24)S6.
Workaround: There is no workaround.
• CSCeg01168
Symptoms: Counters that are displayed in the output of the show interface commands for an ATM
interface of an 8-port OC3 ATM line card show incorrect input packet and byte counts.
Conditions: This symptom is observed on a Cisco 12000 series when the Port Mode Cell Relay
Support feature is configured on the ATM interface.
Workaround: There is no workaround.
• CSCeg01543
Symptoms: A Cisco 7500 series VIP may crash when its serial interfaces are part of a Multipoint
Frame Relay (MFR) bundle.
Conditions: This symptom is observed when a Frame Relay end-to-end fragment is received on an
MFR interface.
Workaround: Administratively shut down the MFR interface or shut down the MFR interface on the
other side of the link.
• CSCeg02511
Symptoms: A Cisco 10000 series may display %CHSTM1-3-STATESYNC error messages, and a
buffer leak may occur.
Conditions: This symptom is observed on a Cisco 10000 series that runs Cisco IOS
Release 12.0(27)S2 when a Fast Ethernet interface is configured to use DHCP via the ip address
negotiated command.
Workaround: Do not configure the ip address negotiated command. Rather, configure a specific IP
address.
• CSCeg03055
Symptoms: Sampled NetFlow may stop functioning.