Installation guide

Cisco 6160 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures

OL-0992-01

Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures

Step 3 Reboot the system to reassociate the system MAC address.

Step 4 Verify that the STATUS LED is solid green on any newly installed line cards after the brief self-test. If

the STATUS LED is not green after the self-test, refer to the Cisco 6160 Hardware Installation Guide

for troubleshooting procedures.

Provision the Octal-Port xTU-C Line Cards

To convert each slot provisioned for 4xflexi DMT to 8xDMT use the following procedure.

Step 1 Record and back up the DSL profiles assigned to each port. Each port will be set to the default

8xDMT profile after provisioning the slot for the new line card.

Step 2 Type the following CLI command:

DSLAM#show running-config

Step 3 Remove the Flexi DMT line card from the desired slot.

Step 4 Type the following CLI Command:

DSLAM# configure terminal

Step 5 To remove Flexi DMT provisioning from slot 1, type the following CLI Command:

DSLAM(config)#no slot 1

Step 6 Type the following CLI Command:

DSLAM(config)#interface atm 1/1

Step 7 Type the following CLI Command:

DSLAM(config-if)#dsl profile profile-name (where profile-name is name recorded previously)

Step 8 Repeat Steps 4 through 7 for ports 2 through 4.

Step 9 For each of the 4 new ports (ports 5 through 8), type the following CLI commands:

a. Type the following CLI Command:

interface atm 1/5

b. Type the following CLI Command:

dsl profile profile-name (where profile-name is the desired profile for the new port)

Step 10 Install the new 8xDMT line card.

Verify CPE Compatibility

Check with a Cisco customer representative to verify CPE compatibility with the 8xDMT.