Installation guide

12
Cisco 6160 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures
OL-0992-01
Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures
Step 2 Hold the 8xDMT vertically, with the line card faceplate toward you and the connectors facing the
chassis slot.
Step 3 Align the line card edge with the guides at the top and bottom of the slot in the Cisco 6160.
Step 4 Lift up on the ejector tab and gently apply pressure to the faceplate while pushing the line card into
the slot.
Figure 2 shows the 8xDMT installation for a Cisco 6160 chassis.
Figure 2 Octal-Port DMT ATU-C Line Card Installation in the Cisco 6160
Step 5 Push on the faceplate of the line card to fully seat the line card.
Step 6 Press down on the ejector tab to secure the line card and connect it to the backplane.
Step 7 Use a flat-head screwdriver to turn the locking tab so that it overlaps the line card ejector tab to prevent
inadvertent dislodging. Figure 3 shows how to position the locking tab.
Figure 3 Positioning the Locking Tab for the Line Card Installation
Note If you are installing the line card for the first time, refer to the provisioning procedures in the
appropriate software guide for your chassis.
NI-2
-155SM-155SM
C
N
S
L
A
U
X
ACO
RESET
T
X
T
R
C
R
X
S
T
A
T
T
X
T
E
S
T
R
C
L
K
S
T
A
T
R
X
TRNK 1
T
X
R
X
T
X
R
X
SBTD 2
CRITICAL
MAJOR
MINOR
POWER
STATUS
ACTIVE
FAN 1
FAN 2
ALARMS
50952
Locked
position
Unlocked
position
27035