Installation guide

13
Installing an 8xDMT
OL-2189-01
Removing and Installing the 8xDMT
Installing an 8xDMT
Complete the following steps to install an 8xDMT in the chassis:
Step 1 Connect a grounding strap to the ESD grounding jack on the chassis.
Step 2 Hold the line card horizontally (Cisco 6015) or vertically (Cisco 6160 or Cisco 6260), with the faceplate
toward you and the connectors facing the chassis slot.
Step 3 Align the line card edges with the guides at the left and right (Cisco 6015) or top and bottom (Cisco 6160
or Cisco 6260) of the slot in the chassis.
Step 4 Lift the ejector lever and gently apply pressure to the faceplate while pushing the line card into the slot.
Figure 3 shows an example of the 8xDMT installation. The installation procedures will be similar for
the other chassis.
Figure 3 Installation of the 8xDMT
Step 5 Push on the faceplate of the line card to fully seat the card.
Step 6 Press down on the ejector lever to secure the line card and connect it to the backplane.
Step 7 Use a flat-head screwdriver to turn the locking tab so that it overlaps the line card ejector lever to
prevent inadvertent dislodging. Figure 2 shows how to position the locking tabs.
Step 8 Verify that the STATUS LED is solid green after the brief self-test. If the STATUS LED is not green
after the self-test, see the appropriate hardware guide for your chassis for troubleshooting procedures.
Note If you are installing the line card for the first time, refer to the provisioning procedures in the appropriate
software guide for your chassis.
NI-2
-155SM-155SM
C
N
S
L
A
U
X
ACO
RESET
T
X
T
R
C
R
X
S
T
A
T
T
X
T
E
S
T
R
C
L
K
S
T
A
T
R
X
TRNK 1
T
X
R
X
T
X
R
X
SBTD 2
CRITICAL
MAJOR
MINOR
POWER
STATUS
ACTIVE
FAN 1
FAN 2
ALARMS
50952