Manualshelf

Installation guide

ManualsBrandsCisco ManualsComputer equipmentNPE-G2 - Network Processing Engine G2
41424344454647484950
7-46
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-08
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Enabling the Second Processor on the NPE-G1
Error Messages
The following error messages are displayed if a feature is configured that is not supported in the MPF
path:
Router# %MPF-4-IGNOREDFEATURES: Interface Gi0/3: Input "PBR" configurations are not MPF
supported and are IGNORED. %SYS-5-CONFIG_I: Configured from console by console
Router# (config-if)# %MPF-4-IGNOREDFEATURES: Interface Gi0/3: Input "PBR" configurations
are not MPF supported and are IGNORED.
%MPF-4-IGNOREDFEATURES: Interface Gi0/3: Output "NetFlow" configurations
are not MPF supported and are IGNORED.
Using show Commands Associated with the mpf Command
There are a variety of show commands associated with the mpf command. They are listed below along
with sample output. Use these commands to verify the mpf installation.
• Using the show interface stats Command, page 7-46
• Using the show ip interface Command, page 7-46
• Using the show mpf cpu Command, page 7-47
• Using the show mpf cpu history Command, page 7-47
• Using the show mpf interface Command, page 7-48
• Using the show mpf ip exact-route Command, page 7-50
• Using the show mpf punt Command, page 7-50
• Using the show version Command, page 7-50
Using the show interface stats Command
Use the show interface stats command for information about the interface.
Router# show interface stats
GigabitEthernet0/1
Switching path Pkts In Chars In Pkts Out Chars Out
Processor 33090 6424353 86353 8645650
Route cache 2 116 0 0
Multi-Processor Fwding 1004 158632 5004 790632
Total 34096 6583101 91357 9436282
Using the show ip interface Command
Use the show ip interface command to get information about the specific interface port.
Router# show ip interface g0/3
GigabitEthernet0/3 is up, line protocol is up
Internet address is 155.1.1.1/16
Broadcast address is 255.255.255.255
Address determined by setup command
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set