Installation guide

7-33
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-08
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Installing the NPE-G1 or NPE-G2
Figure 7-20 Installing the Rear Cable-Management Brackets with the NPE-G1 or NPE-G2—Router
Rear-Mounted
Step 1 Align the cable-management brackets with the rack-mount brackets as shown in Figure 7-20.
Step 2 Insert and tighten two screws for each bracket. The screws come with the cable-management brackets.
Figure 7-21 Attaching Console and Auxiliary Port Cables
Step 3 Insert the console and auxiliary RJ-45 cables into the interface ports on the NPE-G1 or NPE-G2.
Step 4 Place the cables through the cable-management brackets.
1 Screws
GIGABIT ETHERNET 0/1
RJ45 GBIC
EN
RX TX
LINK
CONSOLE
AUX
GIGABIT ETHERNET 0/1
RJ45
GBIC
EN
RX TX
LINK
GIGABIT ETHERNET 0/1
RJ45 GBIC
EN
RX TX
LINK
CPU
RESET
COMPACT FLASH
POWER
ON
SLOT
ACTIVE
NETWORK PROCESSING ENGINE - G1
66750
EN
1
1
1 Console port 4 Cable to console terminal or DTE
2 Auxiliary port 5 Cable to modem or DCE
3 RJ-45 connectors
CONSOLE
AUX
CPU
RESET
COMPACT FLASH
POWER
ON
SLOT
ACTIVE
NETWORK PROCESSING ENGINE - G1
66777
1
2
3
4
5