Specifications

44 Memory Replacement Instructions for the Network Processing Engine and Input/Output Controller
Removing and Replacing Memory DRAM SIMMs, SDRAM DIMMs, and Boot ROMs
Figure 35 Aligning the Network Processing Engine between the Slot Guides in the
Cisco 7200 Series
Figure 36 Aligning the Network Processing Engine between the Slot Guides in the
Cisco uBR7200 Series (Cisco uBR7246 Shown)
Warning
Do not align the network processing engine’s metal carrier between the slot guides. Doing
so will damage components on the network processing engine’s printed circuit board as you slide
the network processing engine into its chassis slot.
Step 5 Gently slide the network processing engine all the way into its chassis slots until you feel
the connectors make contact with the router midplane.
Step 6 Seat the network processing engine in the router midplane by tightening its captive
installation screws with a number 2 Phillips or a 3/16-inch, flat-blade screwdriver.
H6541
Metal carrier
Slot guides
Network processing
engine
Printed circuit board
H11311
Slot guides
Network
processing
engine
Metal
carrier
Printed
circuit
board