Specifications

Memory Replacement Instructions for the Network Processing Engine and Input/Output Controller 29
Removing the Network Processing Engine
Step 6 From the rear of the rack, carefully push the front of the router out of the rack until there
is enough clearance to remove the network processing engine.
Step 7 Grasp the network processing engine handle and carefully pull the network processing
engine from its chassis slot.
Caution Handle the network processing engine by the carrier edges and handle only; never touch
the printed circuit board components or connector pins. (See Figure 10.)
Figure 19 Cisco 7200 Series Network Processing Engine Captive Screws and Handle
Figure 20 Cisco uBR7200 Series Network Processing Engine Captive Screws and
Handle (Cisco uBR7246 Shown)
H6540
Captive
installation
screw
Handle
NETWORK PROCESSING ENGINE-150
Network processing
engine
AC-input
power supply
H11514
Handle
Network
processing
engine
Captive installation screws