Specifications
Memory Replacement Instructions for the Network Processing Engine and Input/Output Controller 27
Removing the Input/Output Controller
Figure 17 Cisco 7200 Series Input/Output Controller Ports, Handle, and Captive Screws
Figure 18 Cisco uBR7200 Series Input/Output Controller Ports, Handle, and Captive
Screws (Cisco uBR7246 Shown)
Step 4
Remove the Flash memory cards or Flash Disks (if present) from the I/O controller’s PC
card slots. (Refer to the “Installing and Removing a Flash Memory Card” section on
page 52; or refer to the Using the Flash Disk document for Flash Disk replacement
instructions.)
Step 5 Using a number 2 Phillips or a 3/16-inch, flat-blade screwdriver, loosen the two captive
installation screws on the faceplate of the I/O controller. (For a Cisco 7200 series router,
see Figure 17. For a Cisco uBR7200 series router, see Figure 18.)
2
MII
EN
RJ45
EN
RJ45
LINK
1O PWR
OK
RJ-45
CPU RESET
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII
ETHERNET-10BFL
EN
RX
0
1
2
3
4
TX
RX
TX
RX
TX
RX
TX
RX
TX
ETHERNET 10BT
ENABLED
0
2
1
3
LINK
0
1
2
3
ENABLED
MII
LINK
RJ45
FAST ETHERNET
0
0
4
1
3
5
6
FAST SERIAL
EN
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TOKEN RING
0
1
2
3
Cisco 7200
Series
H6537
Auxiliary
port
Handle
Console
port
Captive
installation
screw
PC Card slots
I/O controller
Optional Fast Ethernet port
(MII receptacle and RJ-45 receptacle)
H11512
I/O controller
PCMCIA slots
Fast Ethernet port
(MII receptacle and
RJ-45 receptacle)
Handle
Auxiliary port
Console port
Captive installation screw (2)