Specifications

28 Network Processing Engine Replacement Instructions
Removing and Replacing the Network Processing Engine
Figure 17 Aligning the Network Processing Engine Between the Slot Guides on a
Cisco 7200 Series Router
Figure 18 Aligning the Network Processing Engine Between the Slot Guides on a
Cisco uBR7200 Series (Cisco uBR7246 Shown)
Step 6
Gently slide the network processing engine all the way into its chassis slot until you feel
the connectors seat with the router midplane.
Step 7 Seat the network processing engine in the router midplane by tightening its captive
installation screws with a number 2 Phillips or a 3/16-inch flat-blade screwdriver.
Note The network processing engine is not fully seated in the router midplane until you
tighten its captive installation screws.
H6541
Metal carrier
Slot guides
Network processing
engine
Printed circuit board
H11311
Slot guides
Network
processing
engine
Metal
carrier
Printed
circuit
board