Specifications

Network Processing Engine Replacement Instructions 25
Removing the Network Processing Engine
Step 4 Using a 3/16-inch flat-blade screwdriver, loosen the screws that secure the router to the
front mounting strips of the rack.
Step 5 Position at least one person in front of the rack to support the front underside of the router.
Step 6 From the rear of the rack, carefully push the front of the router out of the rack until there
is enough clearance to remove the network processing engine.
Step 7 Grasp the network processing engine handle and carefully pull the network processing
engine from its chassis slot.
Caution Handle the network processing engine by the carrier edges and handle only; never touch
the printed circuit board components or connector pins.
Figure 15 Cisco 7200 Series Network Processing Engine Captive Screws and Handle
H6540
Captive
installation
screw
Handle
NETWORK PROCESSING ENGINE-150
Network processing
engine
AC-input
power supply