Datasheet

Network Analysis Module (NM-NAM)
show controllers analysis-module
68
Cisco IOS Release: Multiple releases (see the Feature History Table)
INTERRUPT STATISTICS
CX = 613298
FR = 805
CNA = 0
RNR = 0
MDI = 0
SWI = 0
FCP = 0
Receive All Multicasts = enabled
Receive Promiscuous = disabled
Loopback Mode = disabled
Table 4 describes the significant fields shown in the display.
Related Commands
Table 4 show controllers analysis-module Field Descriptions
Field Description
Hardware is Description of the chip being used.
IDB, FASTSEND Address in router memory of the Interface
Descriptor Block (IDB) and the fastsend routine.
INSTANCE Device-specific data stored in router memory that
lists the memory locations and current indexes of
receive (Rx) and transmit (Tx) rings in router I/O
memory.
CONTROL AND STATUS REGISTERS (CSR) Control and status registers that are physically
located on the chip itself and that are accessed by
the CPU over the Peripheral Component
Interconnect (PCI) bus.
PHY REGISTERS Contents of the PHY registers. PHY is a device
that interfaces the physical Ethernet line and that
is located between the chip and the physical line.
HARDWARE STATISTICS Receive (Rx) and transmit (Tx) traffic statistics
collected by the chip.
INTERRUPT STATISTICS Transmit (Tx), Receive (Rx), control, software,
and flow control interrupt statistics collected by
the chip.
Command Description
service-module
analysis-module status
Displays hardware and software status information about the NM-NAM.
show interfaces
analysis-module
Displays status, traffic data, and configuration information about the
analysis module interface.