Datasheet

Network Analysis Module (NM-NAM)
service-module analysis-module status
65
Cisco IOS Release: Multiple releases (see the Feature History Table)
service-module analysis-module status
To display hardware and software status information about the Network Analysis Module (NM-NAM),
use the service-module analysis-module status command in privileged EXEC mode.
service-module analysis-module slot/unit status
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Use the service-module analysis-module status command to:
• Display the NAM software release version.
• Check the NAM status (steady or down).
Examples The command in the following example displays information about the NM-NAM in router slot 1:
Router# service-module analysis-module 1/0 status
Service Module is Cisco Analysis-Module1/0
Service Module supports session via TTY line 33
Service Module is in Steady state
Getting status from the Service Module, please wait...
Cisco Network Analysis Module (NM-NAM), version 3.2(0.8)
Related Commands
slot Number of the router chassis slot for the network module.
/unit Number of the daughter card on the network module. For the NM-NAM,
always use 0. The slash mark is required between the slot argument and the
unit argument.
Release Modification
12.3(4)XD This command was introduced on the following platforms:
Cisco 2600XM series, Cisco 2691, Cisco 3660, Cisco 3725, and Cisco 3745.
12.3(7)T This command was integrated into Cisco IOS Release 12.3(7)T.
12.3(8)T4 This command was implemented on the following platforms: Cisco 2811,
Cisco 2821, and Cisco 2851.
12.3(11)T This command was implemented on the Cisco 3800 series.
Command Description
show controllers analysis-module Displays controller information for the analysis module
interface.
show interfaces analysis-module Displays status, traffic data, and configuration information
about the analysis module interface.