Datasheet

Network Analysis Module (NM-NAM)
service-module analysis-module reload
59
Cisco IOS Release: Multiple releases (see the Feature History Table)
service-module analysis-module reload
To perform a graceful halt and reboot of the Network Analysis Module (NAM) software on the
NM-NAM network module, use the service-module analysis-module reload command in privileged
EXEC mode.
service-module analysis-module slot/unit reload
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The service-module analysis-module reload command is the Cisco IOS equivalent of the reboot
NAM CLI command. These commands can be used to initiate the NAM software upgrade process or to
access the NAM helper image.
Examples The following example shows how to gracefully halt and reboot the NAM application software:
Router# service-module analysis-module 1/0 reload
Do you want to proceed with reload?[confirm]
Trying to reload Service Module Analysis-Module1/0.
Related Commands
slot Number of the router chassis slot for the network module.
/unit Number of the daughter card on the network module. For the NM-NAM,
always use 0. The slash mark is required between the slot argument and the
unit argument.
Release Modification
12.3(4)XD This command was introduced on the following platforms: Cisco 2600XM
series, Cisco 2691, Cisco 3660, Cisco 3725, and Cisco 3745.
12.3(7)T This command was integrated into Cisco IOS Release 12.3(7)T.
12.3(8)T4 This command was implemented on the following platforms: Cisco 2811,
Cisco 2821, and Cisco 2851.
12.3(11)T This command was implemented on the Cisco 3800 series.
Command Description
service-module analysis-module
reset
Resets the hardware on the NM-NAM.
service-module analysis-module
shutdown
Gracefully halts the operating system on the NM-NAM.
service-module analysis-module
status
Displays hardware and software status information about the
NM-NAM.