Datasheet

Network Analysis Module (NM-NAM)

How to Configure and Manage the Network Analysis Module (NM-NAM)

Cisco IOS Release: Multiple releases (see the Feature History Table)

• Configuring a Static Route to the NAM Through the Analysis-Module Interface, page 25 (required

for using the internal NAM interface for management traffic)

• Enabling NAM Packet Monitoring, page 27 (required for monitoring traffic through the internal

NAM interface)

• Enabling and Accessing the NAM Traffic Analyzer, page 29 (required)

• Changing the NAM Root Password, page 32 (optional)

• Resetting the NAM Root Password to the Default Value, page 34 (optional)

• Opening and Closing a Telnet or SSH Session to the NAM, page 38 (optional)

• Upgrading the NAM Software, page 41 (optional)

Configuring the Analysis-Module Interface on the Router

This section describes how to configure the Analysis-Module interface on the router. For general

information on the Analysis-Module interface, see the “Analysis-Module Interface” section on page 5.

For information on assigning the IP address of the Analysis-Module interface, see the “NM-NAM

Operating Topologies and IP Address Assignments” section on page 6.

SUMMARY STEPS

1. enable

2. configure terminal

3. interface type number

4. ip address ip-address mask

5. interface analysis-module slot/0

6. ip unnumbered interface number

ip address ip-address mask

7. no shutdown

8. end

9. show ip interface brief

show running-config