Technical data

2-9
Software Configuration Guide for the Cisco VG200
78-10322-02
Chapter 2 Basic Configuration
Basic Configuration with the Initial Configuration Dialog
Step 10 Save the configuration, as follows:
The following configuration command script was created:
hostname vg200
enable secret 5 $1$6F..$Lc8rqF6Nnos33ARvs9Uu7/
enable password cisco
line vty 0 4
password lab
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
full-duplex
ip address 192.168.100.1 255.255.255.0
!
end
:
Use this configuration? [yes/no]: yes
If you answer no, the configuration information you entered is not saved, and the
system displays the gateway enable prompt (VG200 #). You can then enter setup
to return to the initial configuration dialog.
If you answer yes, the configuration is saved and you are returned to the EXEC
prompt (for example, VG200>).
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Step 11 When the messages stop displaying on your screen, press Return to get the EXEC
prompt (for example, VG200>).
Press RETURN to get started!
%LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
...
The VG200> prompt indicates that you are now at the CLI.