Technical data

Chapter 2 Basic Configuration
Basic Configuration with the Initial Configuration Dialog
2-8
Software Configuration Guide for the Cisco VG200
78-10322-02
Step 8 When you see the following prompt, identify the Fast Ethernet interface, which
you must configure to use the VG200.
Current interface summary
Any interface listed with OK? value "NO" does not have a valid
configuration
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 unassigned NO unset up up
Enter interface name used to connect to the
management network from the above interface summary: FastEthernet0/0
d dialing? [no]:
Step 9 Configure the Fast Ethernet interface.
When you see the following prompts, enter the selections shown below, and then
enter the IP address for the gateway on the Ethernet LAN.
Configuring interface parameters:
Do you want to configure FastEthernet0/0 interface [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [no]: yes
IP addresss for this interface: 192.168.100.1