Technical data

2-7
Software Configuration Guide for the Cisco VG200
78-10322-02
Chapter 2 Basic Configuration
Basic Configuration with the Initial Configuration Dialog
Step 3 When the following message appears, enter yes to perform basic management
setup:
Would you like to enter basic management setup? [yes/no]: yes
Step 4 Enter the host name for the VG200, as in the following example:
Configuring global parameters:
Enter host name [Router]: VG200
You must make sure the same entry is used when configuring the Cisco VG200
gateway on Cisco CallManager.
Step 5 When you see the following prompt, enter an enable secret password:
Enter enable secret: xxxx
The enable secret is a password used to protect access to privileged
EXEC and configuration modes. This password, after entered, becomes
encrypted in the configuration.
Step 6 When you see the following prompt, enter an enable password that is different
from the enable secret password.
Enter enable password: guessme
The enable password is used when you do not specify an enable secret
password, with some older software versions, and some boot images.
Note The enable password is not encrypted (less secure) and can
be seen when viewing the configuration.
Step 7 Enter the virtual terminal password, which prevents unauthenticated access to the
gateway through ports other than the console port.
Enter virtual terminal password: guessagain
The virtual terminal password is used to protect access to the gateway
over a network interface.