Technical data

Chapter 2 Basic Configuration
Basic Configuration with the Initial Configuration Dialog
2-6
Software Configuration Guide for the Cisco VG200
78-10322-02
The messages look similar to the following:
######################################################################
######################################################################
############################################################## [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) VG200 Software (VG200-I6S-M), Experimental Version
12.0(20000117:081249) [sfry-viola_eft2 116]
Copyright (c) 1986-2000 by Cisco Systems, Inc.
Compiled Fri 28-Jan-00 22:18 by sfry
Image text-base: 0x80008088, data-base: 0x8066E970
cisco VG200 (MPC860) processor (revision 0x102) with 22528K/2048K
bytes of memory.
Processor board ID JAB034202S3 (0)
M860 processor: part number 0, mask 49
1 FastEthernet/IEEE 802.3 interface(s)
2 Voice FXS interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Step 2 When the following message appears, enter yes to begin the initial configuration
dialog:
Would you like to enter the initial configuration dialog? [yes/no]:
Note If you enter n (for no) in response to this message, you are
prompted to terminate the initial configuration dialog. If you
choose to terminate, you enter the Cisco IOS software
command-line interface without running the configuration
dialog.