Technical data

2-5
Software Configuration Guide for the Cisco VG200
78-10322-02
Chapter 2 Basic Configuration
Basic Configuration with the Initial Configuration Dialog
Step 1 Power on the gateway. The power switch is on the rear panel of the gateway, at the
lower right corner, near the power cord.
Messages will begin to appear in your terminal emulation program window.
Caution Do not press any keys on the keyboard until the messages stop.Any
keys pressed during this time are interpreted as the first command
entered when the messages stop, which might cause the gateway to
power off and start over. It takes a few minutes for the messages to
stop.
Note If you make a mistake while using the initial configuration
dialog, you can exit and run the facility again. Press Ctrl-c,
and enter setup at the enable mode prompt (VG200 #).