Technical data

Chapter 2 Basic Configuration
Basic Configuration with the Initial Configuration Dialog
2-4
Software Configuration Guide for the Cisco VG200
78-10322-02
Channelized E1/T1 ISDN PRI Network Modules
The T1/E1 channelized T1 ISDN PRI network modules available at this time for
the Cisco VG200 are as follows:
• NM-1CT1 1-Port Channelized T1/ISDN PRI Network Module
• NM-1CT1-CSU 1-Port Channelized T1/ISDN PRI CSU Network Module
• NM-2CT1 2-Port Channelized T1/ISDN PRI Network Module
• NM-2CT1-CSU 2-Port Channelized T1/ISDN PRI CSU Network Module
• NM-1CE1B 1-Port Channelized E1/ISDN PRI Balanced Network Module
• NM-1CE1U 1-Port Channelized E1/ISDN PRI Unbalanced Network Module
• NM-2CE1B 2-Port Channelized E1/ISDN PRI Balanced Network Module
• NM-2CE1U 2-Port Channelized E1/ISDN PRI Unbalanced Network Module
Basic Configuration with the Initial Configuration
Dialog
The initial configuration dialog provides prompts to help you configure basic
information about your Cisco VG200 gateway. The following sections describe
the way to use the intial configuration dialog to configure the following
information:
• Host name
• Passwords
• Ethernet interface configuration
The initial configuration dialog displays these prompts in your PC terminal
emulation program window. Before running the initial configuration dialog,
configure your PC terminal emulation program for 9600 baud, 8 data bits, no
parity, and 1 stop bit.
You can also complete the following configuration steps by entering the
appropriate command-line interface(CLI) commands, as described in the “Basic
Configuration with the Cisco IOS CLI” section on page 2-16. Perform the
following steps to complete basic configuration of a Cisco VG200 gateway, using
the initial configuration dialog: