Technical data

Chapter 2 Basic Configuration
Basic Configuration with the Cisco IOS CLI
2-16
Software Configuration Guide for the Cisco VG200
78-10322-02
The following is an example of a E1/T1 PRI mode configuration using the setup
command facility:
The following framing types are available:
esf | sf
Enter the framing type [esf]:
The following linecode types are available:
ami | b8zs
Enter the line code type [b8zs]:
Enter number of time slots [24]:
Do you want to configure Serial1/0:23 interface? [yes]:
Basic Configuration with the Cisco IOS CLI
The Cisco VG200 runs the Cisco IOS Release 12.1(1)XE, which includes
specialized adaptations for Voice over IP (VoIP) and Media Gateway Control
Protocol (MGCP). If you are familiar with other versions of the Cisco IOS, you
will find configuring the Cisco VG200 gateway straightforward because you will
use the Cisco IOS CLI, with which you are familiar.
If you have never used the Cisco IOS CLI, you should still be able to perform the
configuration required using the instructions and examples provided in this guide.
To help get you started, this section provides a brief overview of some of the main
features of the CLI. For further information, refer to the Cisco IOS configuration
guides and command references for details about specific commands.
Getting Help
Use the question mark (?) and arrow keys to help you enter commands, as follows:
• For a list of available commands, enter a question mark, for example:
VG200> ?
• To complete a command, enter a few known characters followed by a question
mark (with no space), for example:
VG200> s?