Technical data

2-15
Software Configuration Guide for the Cisco VG200
78-10322-02
Chapter 2 Basic Configuration
Voice Interface Configuration with the Intial Configuration Dialog
If your service provider assigns you SPIDs, you must define these SPIDs on the
Cisco VG200. To define SPIDs and the local directory number (LDN) on the
Cisco VG200 for both ISDN BRI B channels, use the following isdn spid
commands:
VG200(config-if)# isdn spid1 spid-number [ ldn ]
VG200(config-if)# isdn spid2 spid-number [ ldn ]
Note Although the LDN is an optional parameter in the command, you
may need to enter it so the Cisco VG200 can answer calls made to
the second directory number.
E1/T1 ISDN PRI Configuration
This section contains a sample configuration for the channelized E1/T1 ISDN PRI
interface. Enter the values appropriate for your Cisco VG200 and network.
Note The messages you see will vary depending on the hardware
configuration of your Cisco VG200 gateway.
The following ISDN switch types are available:
[0] none............If you do not want to configure ISDN
[1] primary-4ess....AT&T 4ESS switch type for US and Canada
[2] primary-5ess....AT&T 5ESS switch type for US and Canada
[3] primary-dms100..Northern Telecom switch type for US and
Canada
[4] primary-net5....European switch type for NET5
[5] primary-ni......National ISDN Switch type for the U.S
[6] primary-ntt.....Japan switch type
[7] primary-ts014...Australian switch type
Choose ISDN PRI Switch Type [2]:
Configuring controller T1 1/0 in pri or channelized mode
Do you want to configure this interface controller? [no]:
Will you be using PRI on this controller? [yes]: